| Base Material | Surface Condition | Effective focus depth(mm) | Standard cleaning efficiency (mm/min) | High-speed cleaning efficiency (mm/min) | Cleaning effect |
| Cast iron | Heavy rust (0.08mm thickness) | ＞35 | 2000 | 3000 | Clean surface, no damage to the base metal |
| Carbon steel | Moderate corrosion (0.05mm thickness) | ＞40 | 2000 | 2500 | Clean surface, no damage to the base metal |
| Stainless steel | Surface oil, slightly rust | ＞50 | 2000 | 2800 | Clean surface, no damage to the base metal |
| Mold steel gear | Moderate oil stain, attached iron filings | ＞40 | 3000 | 3200 | Clean surface, no damage to the base metal |
| Aluminum plate | Oxide/surface contamination | ＞35 | 2500 | 3000 | Clean surface, no damage to the base metal |
| No putty paint layer | White pigmented paint (0.1mm thickness) | ＞20 | 1800 | 2000 | Clean surface, no damage to the base metal |
Cleaning system settings Information
● Field lens selection
Focusing mirror parameter selection, optional display 160mm focal
length, 254mm focal length, 330mm focal length
● Galvanometer speed
The mirror swing speed is adjustable. The X mirror is 50HZ at the
fastest and 50/30 per gear. The Y mirror is 200HZ at the fastest
and 200/30 per gear.
● Laser frequency
Laser pulse frequency, 1K-200K optional.
● Laser power
Laser output power can be adjusted from 1 to 100.
● Laser pulse width
Use it while using an adjustable pulse width laser machine
● Graphic length (laser pattern is square)
The length of the laser beam. The maximum length is 120MM, and the
length can be adjusted freely within 0-120mm range.
● Graphic width (laser pattern is square)
The width is up to 4MM, and the width can be adjusted freely within
0-40mm range.
● Filling pitch
The distance between lasers while cleaning with a circular laser.
● Opening delay and closing delay
When the laser galvanometer speed is too fast and the graphic
length is too long, the ideal effect can be achieved by setting the
switching light delay.
● Outer circle radius (laser pattern is ring)
The max. outer radius of the graphic outer circle is 40 mm, and the
radius can be adjusted during the circular size. When the graph is
circular, the inner circle radius is set to 0.
● Inner circle radius (laser pattern is ring)
The figure is a ring, and the radius of the inner circle can be set
up to 40MM (but not larger than the radius of the outer circle). In
this range, the radius can be adjusted to change the ring size.
● Application
While parameters were set in the interface. If you enable this set
of parameters, click Application.
● Save
After set the parameters in the interface, remember to click “Save”
to save the parameters for the next direct use.
● Red light
When the button is pressed, the red button turns red and the red
light comes out. Press again and the red button will return to gray
and turn off the red light.
● Laser
Laser light button, press the button, the laser light comes out. If
the red light is emitted at this time, the laser will be forced
out. Press the laser button again to turn off the laser light and
the button will return to gray.
● Group
Mode selection, you can save nine sets of data. Click on the number
on the left side of the mode, you can select the set mode
parameters freely, click on the application. Remember to save the
data after the parameter wat set in each interface.
